Configuring The Io-Link Master 6Es7148-6Jd00-0Ab0 - Siemens SIMATIC ET 200eco PN Operating Instructions Manual

Configuring
4.2 Configuring an IO-Link master
4.2.2

Configuring the IO-Link Master 6ES7148-6JD00-0AB0

Introduction
The IO-Link Master 6ES7148-6JD00-0AB0 is configured and parameters are assigned in the
user interface of the selected configuration software.
"Configuring" is understood to mean arranging, setting and networking of devices and
modules.
"Assigning parameters" is understood to mean setting the properties of the components
used. The parameters of the hardware and the settings for the data exchange are assigned
in the process.
Configuring the submodule of the IO-Link master
Requirements
● You have configured your automation system.
● In the device configuration of the 6ES7148-6JD00-0AB0 IO-Link Master, you have
selected the IO-Link port that you want to configure.
Procedure
1. You configure the operating mode of the submodule. An overview of possible operating
modes is available in the chapter Configuration (Page 222).
2. When you have configured the submodule and thus defined the operating mode, make
the additional settings:
● Enable the Autostart parameter (without S7-PCT)
Note
Changes to the port configuration
If you have assigned the parameters for the IO-Link device via Autostart (without S7-
PCT), or have configured the port as digital input, digital output or disabled, you can no
longer change the port configuration via S7-PCT.
● Enabling the diagnostics (only in IO-Link mode)
● Enable the parameter assignment for the hardware interrupts (only in IO-Link mode)
Response after "Resetting the IO-Link settings" via S7-PCT
● Deleting the IO-Link device data in the backup memory or the IO-Link Master
● Resetting the parameters to factory state:
– Resetting the inspection severity and the backup behavior
Note
Effects on the device configuration
If you have reset the IO-Link settings via S7-PCT, you have to reload the device
configuration via S7-PCT.
70
Operating Instructions, 08/2016, A5E01250250-AJ
ET 200eco PN