Maintenance Interrupts - Siemens SIMATIC ET 200eco PN Operating Instructions Manual

Interrupt, error, and system messages

7.2 Maintenance interrupts

7.2 Maintenance interrupts
Introduction
The PROFINET interfaces of the ET 200eco PN support the diagnostics concept and
maintenance concept in PROFINET as defined in IEC 61158-6-10. The objective is early
detection and elimination of potential disturbances.
Maintenance interrupts
The following maintenance interrupts are available for the ET 200eco PN:
● Sync mismatch (no synchronization)
● Jitter out of Boundary (jitter too high)
● Frame dropped (frames are discarded)
● I/O error (with IO-Link devices)
STEP 7
System alarms in
The maintenance information is generated in
● Maintenance required, identified by a yellow wrench icon at the relevant port.
See also
For additional information, refer to the SIMATIC PROFINET system description
(http://support.automation.siemens.com/WW/view/en/19292127) System Manual and the
Migration from PROFIBUS DP to PROFINET IO
(http://support.automation.siemens.com/WW/view/en/19289930) Programming Manual.
84
STEP 7
with the following system alarms:
Operating Instructions, 08/2016, A5E01250250-AJ
ET 200eco PN