Setting The Maximum Number Of Ipv6 Source Guard Entries Allowed On A Port; Displaying And Maintaining Ip Source Guard - HP 10500 Series Configuration Manual

Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Configure a static IPv6
binding entry on a port.
Setting the maximum number of IPv6 source guard entries
allowed on a port
The maximum number of IPv6 source guard entries is used to limit the number of static IPv6 source guard
entries on a port. When the number of IPv6 binding entries on a port reaches the maximum, the port no
longer allows new IPv6 binding entries.
If the maximum number of IPv6 binding entries to be configured is smaller than the number of existing
IPv6 binding entries on the port, the maximum number can be configured successfully, and the existing
entries are not affected. New IPv6 binding entries, however, cannot be added until the number of IPv6
binding entries on the port drops below the configured maximum.
To configure the maximum number of IPv6 binding entries allowed on a port:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view.
3. Configure the maximum
number of IPv6 binding
entries allowed on the port.

Displaying and maintaining IP source guard

Displaying and maintaining IPv4 source guard:
Task
Display static IPv4 source guard
entries (in standalone mode).
Command
system-view
interface interface-type
interface-number
ipv6 source binding { ipv6-address
ipv6-address | ipv6-address
ipv6-address mac-address
mac-address | mac-address
mac-address } [ vlan vlan-id ]
Command
system-view
interface interface-type
interface-number
ipv6 verify source max-entries
number
Command
display ip source binding static [ interface
interface-type interface-number |
ip-address ip-address | mac-address
mac-address ] [ slot slot-number ] [ | { begin
| exclude | include } regular-expression ]
242
Remarks
N/A
N/A
By default, no static IPv6 binding
entry is configured on a port.
IP source guard does not use the
VLAN information (if specified) in
static IPv6 binding entries to filter
packets.
Remarks
N/A
N/A
Optional.
The default maximum number is
256.
Remarks
Available in any view.