Ipv6 Nd Protocol - HP 5920 Series Configuration Manual

Multicast addresses
IPv6 multicast addresses listed in
Table 7 Reserved IPv6 multicast addresses
Address
FF01::1
FF02::1
FF01::2
FF02::2
Multicast addresses also include solicited-node addresses. A node uses a solicited-node multicast
address to acquire the link-layer address of a neighboring node on the same link and to detect duplicate
addresses. Each IPv6 unicast or anycast address has a corresponding solicited-node address. The format
of a solicited-node multicast address is FF02:0:0:0:0:1:FFXX:XXXX. FF02:0:0:0:0:1:FF is fixed and
consists of 104 bits, and XX:XXXX is the last 24 bits of an IPv6 unicast address or anycast address.
EUI-64 address-based interface identifiers
An interface identifier is 64-bit long and uniquely identifies an interface on a link. Interfaces generate
EUI-64 address-based interface identifiers differently.
On an IEEE 802 interface (such as an Ethernet interface and a VLAN interface)—The interface
•
identifier is derived from the link-layer address (typically a MAC address) of the interface. The MAC
address is 48-bit long. To obtain an EUI-64 address-based interface identifier, insert the
hexadecimal number FFFE (16 bits of 1 1 1 1 1 1 1 1 1 1 1 1 1 1 10) into the MAC address (behind the 24th
high-order bit), and set the universal/local (U/L) bit (which is the seventh high-order bit) to 1,
ensuring that the obtained interface identifier is globally unique.
Figure 51 Converting a MAC address into an EUI-64 address-based interface identifier
• On a tunnel interface—The lower 32 bits of the EUI-64 address-based interface identifier are the
source IPv4 address of the tunnel interface. The higher 32 bits of the EUI-64 address-based
interface identifier of an ISATAP tunnel interface are 0000:5EFE, whereas those of other tunnel
interfaces are all zeros. For more information about tunnels, see
On an interface of another type—The EUI-64 address-based interface identifier is generated
•
randomly by the device.

IPv6 ND protocol

The IPv6 Neighbor Discovery (ND) protocol uses the following ICMPv6 messages:
Table 7 are reserved for special purposes.
Application
Node-local scope all-nodes multicast address.
Link-local scope all-nodes multicast address.
Node-local scope all-routers multicast address.
Link-local scope all-routers multicast address.
115
"Configuring tunneling."