2. Click
[Load]
and choose an .stl file from hard drive.
3. The object will then be shown on the screen.
4. Click
[Load]
and choose another (or the same) file from hard drive.
5. Click on the object and then click on [Extruder], select
NOTE: one object is turned to green, that indicates it will be print wit the left
extruder.
6. Now the 3D model is ready to be created.
Before introducing the connection methods, let me give you a brief introduction of
Inventor's interfaces.
Inventor User Guide | www.FlashForge.com
[Use left
Print
Read the print file from
The local memory card
The SD card
Back
53
extruder].
400-699- 1063