Flashforge Inventor User Manual page 35

6.2.7
Scale
Select the target object and scale the object by the following two methods:
Method 1: Click the
and scale the model. The corresponding values will display near the object..
Method 2: Click the
in X/Y/Z axes positioning. Click the
[Reset]
for building. Click
Note: If the [Uniform Scaling]
proportion when changing
only change the value of the corresponding positioning.
6.2.8
Cut
Left-click on the model to select it and double-click on the
plane. The direction and position are available for setting.
①Draw with Mouse
Inventor User Guide | www.FlashForge.com
[Scale] icon
[Scale] icon
[Maximum]
to reset the size of model.
radio button is clicked, it will scale the model in equal
value in any positioning of the model. Otherwise it will
on the left, hold down the left mouse button
on the left and then enter into scale values
button to get largest size possible
[Cut]
35
icon to set the cut
400-699- 1063