Flashforge Inventor User Manual page 41

b. Fill Pattern is the pattern of filling shape which effects printing duration.
c. Combine Infill: You can select the layers for combining according to the layer
thickness. The combined thickness should not exceed 0.4mm. "Every N layers" is for
all the infills while "Every N inner layers" is only for inner infills, which generally
can save print time.
● Speed
a. Print Speed is the moving speed of the extruder. Generally, the lower the
speed is, the better print you will get. For PLA printing, 80 mm/s is recommended.
b. Travel Speed is to control the moving speed of the extruder under
non-printing Status during work. for PLA printing, 100 mm/s is recommended.
Note: Modify parameters settings to get better prints as different models need
different parameters.
● Temperature
Right Extruder Temperature: Recommended extruder temperature is 230℃.
Note: Different temperatures have subtle influences in prints. Please adjust the
temperature according to the condition in order to get a good print.
Platform Temperature: To set the temperature of Platform.
● Others
Cooling Fan Control: Set up the time to turn on the cooling fan. You can pre-set
the height and make the cooling fan begin to work at the point.
Pause At Heights: Allows users to preset a height in which the print will
suspend automatically. The function usually applied when you want to change the
Inventor User Guide | www.FlashForge.com
6-14
41
400-699- 1063