Flashforge Inventor User Manual page 30

Method 5: Click [File]--[Recent Files] to load the files opened recently.
Method 6: Select and drag the target file to the icon of FlashPrint.
Note: .STL, .OBJ, .3MF and .FPP, ways to store 3D models, are supported by
FlashPrint for editing.
Generating Rilievo
Load a png, jpg, jpeg, bmp picture file into the FlashPrint. And the following dialogue
box (6-4) will pop up. The setting box includes settings for shape, mode, maximum
thickness, base thickness, bottom thickness, width, height, top diameter and bottom
diameter.
Shape: including plane, tube, canister and lamp.
Mode: including "darker is higher" and "lighter is higher".
Maximum thickness: Z value of the model
Base thickness: The minimum raft thickness and the default value is 0.5mm
Width: X value of the model
Depth: Y value of the model
Bottom thickness: To set up bottom thickness for tube, canister, lamp and seal.
Top diameter: To set up the top diameter for tube, canister, lamp and seal.
Bottom diameter: To set up the bottom diameter for tube, canister, lamp and seal.
6-4
Inventor User Guide | www.FlashForge.com 400-699- 1063
30