Flashforge Inventor User Manual page 26

5. （5-5）Tap [Next]
6. （5-6）Tap [Next]. The nozzle will move to the center of the build plate. Slide the
paper through to make sure there is a slight friction. Slowly adjust all the screws by
the same amount if there is no friction or too much friction.
[Finish]
7. （5-7）Tap
Inventor User Guide | www.FlashForge.com
5-5
again and repeat the same leveling steps.
5-6
5-7
once you have finished this.
26
400-699- 1063
25