Flashforge Inventor User Manual page 47

6-22
8. Restart the interface, close the page, turn off the Inventor, disconnect from the
network, and wait for 10 seconds.
9. Turn on the Inventor again and connect your computer to the network named
"Inventor1" . Click [Print]-[Connect] in FlashPrint.
10. Under Mode", select Wi-Fi, and enter the Address" as shown
"Connection "IP
on Inventor's touch screen. Then, click [Connect].
10. If successfully connected, you will see the following red mark.
Disconnect Inventor
[Print]--[Disconnect]
Click to disconnect your PC and Inventor.
6.2.14 Tool Menus
①Control Panel
[Tools]--[Control Panel]
After connecting PC with Inventor, click to open the control
panel.
Inventor User Guide | www.FlashForge.com 400-699- 1063
47