Flashforge Inventor User Manual page 42

filament at a certain point.
6-15
(6-15) Click[Edit], then you can add or remove a height.
6.2.12 File Menus
① New Project
[File]--[New Project]
Click can build a blank project. If there is an unsaved
modification on previous project, then will inform you whether the modification
needs to be saved or not. Click [Yes] will save the modification, click [No] will
abandon it. If click [Cancel] or close tool tip, then will cancel the new project.
6-16
② Saving
After finishing the model edit and adjustment, there are two ways below to save all
models in the scene.
Method 1:
[File]--[Save Project]
Click in the menu bar, can save the file as a project file which
suffix is ".fpp" in this type of file,all models in the scene (include support) are
independent .after reloading the files, extruder configuration information and model
position will be same as the configuration during saving.
Inventor User Guide | www.FlashForge.com 400-699- 1063
42