Flashforge Inventor User Manual page 59

[More Options]
set under icon.
3. Click [OK], and save the gcode file in the SD card.
4. FlashPrint will begin slicing the 3D model.
5.
After the object is done slicing, take the SD card out from the computer. Insert it
into the SD card slot on the Inventor.
6. Turn on the Inventor. Make sure the build plate is leveled and filament is loaded on
the left extruder.
7. Tap [Print] and then tap the middle SD Card icon.
8. A list of file(s) will show up, tap the file that you would like to print, then tap [Yes].
9. The printer will now enter preheating phase and will start printing once it finishes
preheating
Printing via Wi-Fi
1. Turn on Inventor. Make sure the build plate is leveled and filament is loaded on the
left extruder
2. Turn on Wi-Fi on the Inventor. Then tap [Tool]-[Setting]-[WiFi]-[WiFi ON].
3. A connection called "Inventor1" can be found on your computer available
networks list. Connect your computer to this network.
4. Open your Internet browser in your computer. Type in "10.10.100.254" and hit
[Enter] on your keyboard. Enter the username and password to login. The default
username and password are both "admin." The control panel will appear after a
successful login.
Inventor User Guide | www.FlashForge.com 400-699- 1063
59