Chapter 3. Unpacking - Flashforge Inventor User Manual

(Reference video:Unpacking)
This chapter will present you the whole unpacking procedure of Inventor 3D
printer.(Note: Make sure you read the whole unpacking guide)
1. （3-1）Put Inventor package on the clean, tidy workbench,using a knife to cut the
tape ,then you can see two pieces of
Service Card
and a
Printer.
2. （3-2）Remove the top protective foam pieces, which also houses the Inventor's
lid. Set this aside for now. The Inventor unit and a
3. （
3-3 ） Lift the Inventor by its side openings and place it on a flat surface. Then
you will see the Toolbox
Inventor User Guide | www.FlashForge.com

Chapter 3. Unpacking

Quick Start Guide, which will guide you know our Inventor 3D
3-1
and USB cable
Build Tape, a Leveling
Power Cable
3-2
in the shipping box. In the
14
Card, a After-sales
will then be exposed.
Toolbox, you can
400-699- 1063