Plugging In Power Cable&Usb Cable; Loading And Unloading Filament - Flashforge Inventor User Manual

4.3 Plugging in Power Cable&USB Cable
(4-7) Locate the power cable, and plug it into the Inventor.
Optional: Locate the USB cable and plug one end into the Inventor and the other into
your computer. The Inventor supports USB connectivity.

4.4 Loading and Unloading Filament

Filament must pass through the extruder and into the heating block in order to be
melted. In this user guide, we will demonstrate loading and unloading filament using
the left side extruder.
Loading filament:
(4-8) Remove the lid of the Inventor
Inventor User Guide | www.FlashForge.com
4-7
4-8
20
400-699- 1063