Flashforge Inventor User Manual page 25

2. （5-2）Take out the leveling card (Leveling video can be acquired by scanning the
QR Code)
3. （5-3）Once the extruder and build plate stops moving, slide the piece of paper
continuously back and forth between the nozzle and the build plate. And
simultaneously adjust the knob just enough so that the paper causes a slight friction.
[Next]
4. （5-4）Tap
the paper back and forth again, and adjust the screw to create the same amount of
friction as the previous step.
Inventor User Guide | www.FlashForge.com
5-3
5-4
and wait for the extruder to move to the second position. Slide
25
400-699- 1063