Chapter 4 . Hardware Assembly; Mounting The Extruder Set - Flashforge Inventor User Manual

Chapter 4 . Hardware Assembly

The Inventor comes pre-assembled and is almost ready-to-print (ARP). All you need
to do is to set the appropriate voltage, mount the extruder set, and install the filament.
It will only take 5 to 10 minutes to set up the Inventor and prepare for your first 3D
print!

4.1 Mounting the Extruder Set

4-1
(4-1) Lay the extruder set on top of the extruder seat with the two extruder fans facing
the front.
4-2
(4-2) Secure the extruder set onto the extruder seat with two M3x12 from the bottom
up.
Inventor User Guide | www.FlashForge.com 400-699- 1063
17