Flashforge Inventor User Manual page 49

you set last time.
g. X/Y Speed and Z Speed: Set the move speed of extruder/ build platform.
● Limit Switch: In order to protect your Inventor, three limit switches are equipped
to control the maximum position, and the three limit switches corresponding to X/Y/Z
axis limit switch. It has two statuses:
a. Not Triggered: If the extruder/build plate don't move to its maximum, X/Y/Z axis
limit switch is not triggered, and shows "Not Triggered".
b. Triggered: If the extruder/build plate moves to its maximum, X/Y/Z axis limit
switch is triggered, and shows "Triggered".
● Stepper Motor Controls: Allows users to control to stepper motor. Click [Enable],
and lock the motor so it does not allow any movement; click [Disable], and unlock
the motor to be controlled manually.
● LED Color: Allows users to change the LED color of Inventor.
● Extruder Controls: You can set the value of "Motor Speed (RPM)", which can
control the rotation speed of filament feeding wheel. The motor rotation time can be
controlled via setting the value of "Extruder Duration". Generally we suggest the
users choose option of continuous time 60 seconds. The filament must be loaded in
the extruder before motor starts. Therefore, do not start rotation operation until
the extruder temperature reach the printing temperature of filament.
For PLA
filament, the extruder temperature should reach 220℃, after reaching the extruder
[Forward]/[Reverse]
temperature, click the rotation button to control filament load
and filament unload. Furthermore, if you want to stop filament load and unload, you
can click [Stop].
● Temperature Control: Input the temperature you want to get in the left frame,
click [Apply], the printer will automatically heat the corresponding part, the right side
shows the current actual temperature of corresponding part. After start heating, the
Inventor User Guide | www.FlashForge.com 400-699- 1063
49