Flashforge Inventor User Manual page 34

Click [View]--[Show Steep
model surface and horizontal line is within the overhang threshold value, the surface
has steep overhang and it becomes red in the software. Overhang threshold value
could be set as needed. The default value is 45 degree.
6.2.5
Move
Select the object and move the object by the following two methods:
Method 1: Click the
button and drag to adjust the location of the model in XY direction. Hold down the
Shift
key, hold down the left mouse button and drag to adjust the location of the
model in Z direction. The distance and the direction of the movement shall be
displayed.
Method 2: Click the
Click [Reset] to reset distance values.
Note: Users shall click
ensure the model(s) be within the build area and on the build platform. If a specified
position is needed, only click
6.2.6
Rotate
Select the target object and rotate the object by the following two methods:
Method 1: Click the
perpendicular rings appear around the object Click one ring and rotate on the present
axis, you will see the rotation angle and direction in the center of circle. In this way,
you could make the model rotate on X/Y/Z axis.
Method 2: Click the
angel values in X/Y/Z axes positioning. Click
Inventor User Guide | www.FlashForge.com
Overhang]. When the intersection angle between the
[Move]
icon
[Move] button on the left and then enter the distance value.
[Center] and [On Platform]
[On Platform].
[Rotate]
icon
[Rotate] icon
on the left, hold down the left mouse
after the location adjustment to
on the left and three mutually
on the left, and then enter into rotating
[Reset]
to reset rotating angel values.
34
400-699- 1063