Static-Lsp Transit - HP FlexFabric 12500 Command Reference Manual

Default
No static LSP exists on the device.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
lsp-name: Specifies a name for the static LSP, a case-sensitive string of 1 to 15 characters.
destination dest-addr: Specifies a destination IP address for the LSP.
mask: Specifies the mask of the destination IP address.
mask-length: Specifies the mask length of the destination address, in the range of 0 to 32.
nexthop next-hop-addr: Specifies a next hop address.
outgoing-interface interface-type interface-number: Specifies an outgoing interface by its type and
number. The device does not support this option.
out-label out-label: Specifies an outgoing label in the range of 16 to 1023.
Usage guidelines
The next hop or outgoing interface specified for the LSP must be consistent with that of the optimal route
destined for the specified address. If you configure a static IP route for the LSP, be sure to specify the same
next hop or outgoing interface for the static route and the static LSP.
You must enable MPLS on the outgoing interface of the static LSP.
Examples
# Configure a static LSP on the ingress node: specify the LSP's name as bj-sh, destination address as
202.25.38.1/24, next hop address as 202.55.25.33, and outgoing label as 237.
<Sysname> system-view
[Sysname] static-lsp ingress bj-sh destination 202.25.38.1 24 nexthop 202.55.25.33
out-label 237
Related commands
display mpls static-lsp

static-lsp transit

Use static-lsp transit to configure the transit node of a static LSP.
Use undo static-lsp transit to delete the transit node configuration for a static LSP.
Syntax
static-lsp transit lsp-name in-label in-label { nexthop next-hop-addr | outgoing-interface interface-type
interface-number } out-label out-label
undo static-lsp transit lsp-name
23