Routing-Table Limit - HP FlexFabric 12500 Command Reference Manual

Examples
# In OSPF process 100, set the external route tag for redistributed VPN routes to 100.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] route-tag 100
Related commands
import-route

routing-table limit

Use routing-table limit to limit the maximum number of active routes in a VPN instance.
Use undo routing-table limit to restore the default.
Syntax
routing-table limit number { warn-threshold | simply-alert }
undo routing-table limit
Default
The maximum number of active routes depends on the system operating mode.
Views
VPN instance view, IPv4 VPN view, IPv6 VPN view
Predefined user roles
network-admin
mdc-admin
Parameters
number: Specifies the maximum number of active routes. The value range depends on the system
operating mode. For more information about system operating modes, see Fundamentals Configuration
Guide.
warn-threshold: Specifies a warning threshold in the range of 1 to 100 in percentage. When the
percentage of the number of existing active routes to the maximum number of active routes exceeds the
specified threshold, the system gives an alarm message but still allows new active routes. If active routes
in the VPN instance reach the maximum, no more active routes are added.
simply-alert: Specifies that when active routes exceed the maximum number, the system still accepts
active routes but generates a system log message.
Usage guidelines
A limit configured in VPN instance view applies to both the IPv4 VPN and the IPv6 VPN.
A limit configured in IPv4 VPN view or IPv6 VPN view applies to only the IPv4 VPN or the IPv6 VPN.
IPv4/IPv6 VPN prefers the limit configured in IPv4/IPv6 VPN view over the limit configured in VPN
instance view.
Examples
# Specify that VPN instance vpn1 supports up to 1000 active routes, and when active routes exceed the
upper limit, can receive new active routes but generates a system log message.
92