Display Mpls Ldp Fec - HP FlexFabric 12500 Command Reference Manual

Table 12 Command output
Field
Link Hellos
Interface
Hello Interval
Hello Sent/Rcvd
Transport Address
Peer LDP ID
Source Address
Transport Address
Hello Hold Time
Targeted Hellos
100.100.100.17 -> 100.100.100.18
(Active, Passive)

display mpls ldp fec

Use display mpls ldp fec to display LDP FEC-label mappings.
Syntax
display mpls ldp fec [ vpn-instance vpn-instance-name ] [ destination-address mask-length | summary ]
Views
Any view
Predefined user roles
network-admin
network-operator
Description
Information about basic discovery that sends Link Hellos on
interfaces.
In a non-point-to-point network, an interface might discover
multiple peers.
Interface using basic discovery.
Hello interval in milliseconds.
Number of hellos sent or received on the interface.
Local transport address.
LDP identifier of the LDP peer.
Source IP address of received Hello messages.
Transport address in the received Hello messages—the
transport address of the LDP peer.
Hello hold time in seconds.
Local—Local hello hold time.
Peer—Peer hello hold time.
The negotiated hello hold time is the smaller value of the local
and peer hold time values.
Information about extended LDP discovery that sends Targeted
Hellos to peers.
•
The address before -> (100.100.100.17 in this example) is
the local LSR ID.
•
The address after -> (100.100.100.18 in this example) is the
LSR ID of the peer.
•
(Active) indicates that the local LSR is the Targeted Hello
sender.
•
(Passive) indicates that the local LSR is the Targeted Hello
receiver.
•
(Active, Passive) indicates that the local LSR is both the
Targeted Hello sender and receiver.
30