Peer - HP FlexFabric 12500 Command Reference Manual

Usage guidelines
The PEs at the two ends of an LDP PW must have the same MTU. Otherwise, the PW cannot come up.
The MTU specifies the maximum packet length, including the control word, PW label, and network layer
packet.
Examples
# Configure an MTU of 1400 bytes for the cross-connect ac2pw in the cross-connect group vpn1.
<Sysname> system-view
[Sysname] xconnect-group vpn1
[Sysname-xcg-vpn1] connection ac2pw
[Sysname-xcg-vpn1-ac2pw] mtu 1400
Related commands
display l2vpn xconnect-group

peer

Use peer to configure a PW for a cross-connect and enter cross-connect PW view. If the specified PW has
been created, the command opens cross-connect PW view.
Use undo peer to delete a PW.
Syntax
peer ip-address pw-id pw-id [ in-label label-value out-label label-value ] [ pw-class class-name |
tunnel-policy tunnel-policy-name ] *
undo peer ip-address pw-id pw-id
Default
No PW is configured for a cross-connect.
Views
Cross-connect view
Predefined user roles
network-admin
mdc-admin
Parameters
ip-address: Specifies the LSR ID of the peer PE.
pw-id pw-id: Specifies a PW ID for the PW, in the range of 1 to 4294967295.
in-label label-value: Specifies the incoming label of the PW, in the range of 16 to 1023.
out-label label-value: Specifies the outgoing label of the PW, in the range of 16 to 1023.
pw-class class-name: Specifies a PW class by its name, a case-sensitive string of 1 to 19 characters. You
can configure the PW type and control word by specifying a PW class. If no PW class is specified, the
PW type is determined by the interface type. The control word function is not supported for PW types that
do not require using control word.
tunnel-policy tunnel-policy-name: Specifies a tunnel policy by its name, a case-sensitive string of 1 to 19
characters. If no tunnel policy is specified, the default tunnel policy is used.
135