Default
No static LSP exists on the device.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
lsp-name: Specifies a name for the static LSP, a case-sensitive string of 1 to 15 characters.
in-label in-label: Specifies an incoming label in the range of 16 to 1023.
nexthop next-hop-addr: Specifies a next hop address.
outgoing-interface interface-type interface-number: Specifies an outgoing interface by its type and
number. The specified interface must be a point-to-point interface. The device does not support this
option.
out-label out-label: Specifies an outgoing label in the range of 16 to 1023.
Usage guidelines
You must enable MPLS on the outgoing interface of the static LSP.
The static LSP must not have the same incoming label as an existing static CRLSP or static PW. If it is the
same, the static LSP will not be available, even if you modify the incoming label of the static CRLSP or the
static PW. To make the static LSP available, delete the static LSP, and reconfigure it with an unused
incoming label.
Examples
# Configure a static LSP on the transit node: specify the LSP's name as bj-sh, incoming label as 123, next
hop address as 202.34.1 14.7, and outgoing label as 253.
<Sysname> system-view
[Sysname] static-lsp transit bj-sh in-label 123 nexthop 202.34.114.7 out-label 253
Related commands
display mpls static-lsp
24