Sham-Link - HP FlexFabric 12500 Command Reference Manual

<Sysname> system-view
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] route-distinguisher 100:1
[Sysname-vpn-instance-vpn1] routing-table limit 1000 simply-alert
# Specify that the IPv4 VPN vpn2 supports up to 1000 active routes, and when active routes exceed the
upper limit, can receive new active routes but generates a system log message.
<Sysname> system-view
[Sysname] ip vpn-instance vpn2
[Sysname-vpn-instance-vpn2] route-distinguisher 100:2
[Sysname-vpn-instance-vpn2] address-family ipv4
[Sysname-vpn-ipv4-vpn2] routing-table limit 1000 simply-alert
# Specify that the IPv6 VPN vpn3 supports up to 1000 active routes, and when active routes exceed the
upper limit, can receive new active routes but generates a system log message.
<Sysname> system-view
[Sysname] ip vpn-instance vpn3
[Sysname-vpn-instance-vpn3] route-distinguisher 100:3
[Sysname-vpn-instance-vpn3] address-family ipv6
[Sysname-vpn-ipv4-vpn3] routing-table limit 1000 simply-alert

sham-link

Use sham link to create an OSPF sham link.
Use undo sham link to remove a sham link or restore the defaults of specified parameters for a sham link.
Syntax
sham-link source-ip-address destination-ip-address [ cost cost | dead dead-interval | hello hello-interval
| { { hmac-md5 | md5 } key-id { cipher cipher-string | plain plain-string } | simple { cipher cipher-string
| plain plain-string } } | retransmit retrans-interval | trans-delay delay ] *
undo sham-link source-ip-address destination-ip-address [ cost | dead | hello | { { hmac-md5 | md5 }
key-id | simple } | retransmit | trans-delay ] *
Default
No OSPF sham link is configured.
Views
OSPF area view
Predefined user roles
network-admin
mdc-admin
Parameters
source-ip-address: Specifies the source IP address of the sham link.
destination-ip-address: Specifies the destination IP address of the sham link.
cost cost: Specifies the cost of the sham link, in the range of 1 to 65535. The default cost is 1.
93