Mpls Ldp Transport-Address - HP FlexFabric 12500 Command Reference Manual

[Sysname-ldp-peer-3.3.3.3] mpls ldp timer keepalive-interval 50
# On interface VLAN-interface 2, set the Link Hello hold time to 100 seconds, Link Hello interval to 20
seconds, Keepalive hold time to 50 seconds, and Keepalive interval to 10 seconds.
<Sysname> System-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] mpls ldp timer hello-hold 100
[Sysname-Vlan-interface2] mpls ldp timer hello-interval 20
[Sysname-Vlan-interface2] mpls ldp timer keepalive-hold 50
[Sysname-Vlan-interface2] mpls ldp timer keepalive-interval 10
Related commands
• display mpls ldp discovery
display mpls ldp peer
•

mpls ldp transport-address

Use mpls ldp transport-address to specify the LDP transport address.
Use undo mpls ldp transport-address to restore the default.
Syntax
In interface view:
mpls ldp transport-address { ip-address | interface }
undo mpls ldp transport-address
In LDP peer view:
mpls ldp transport-address ip-address
undo mpls ldp transport-address
Default
In interface view, if the interface belongs to the public network, the LDP transport address is the local LSR
ID. If the interface belongs to a VPN, the LDP transport address is the primary IP address of the interface.
In LDP peer view, the LDP transport address is the local LSR ID.
Views
Interface view, LDP peer view
Predefined user roles
network-admin
mdc-admin
Parameters
ip-address: Specifies the LDP transport address.
interface: Uses the IP address of the current interface as the LDP transport address.
Usage guidelines
Before two LSRs establish an LDP session, they must establish a TCP connection by using the LDP transport
address. LDP sends the local LDP transport address to the peer in Link Hello or Targeted Hello messages.
52