Table of Contents
Advertisement
Setting System Configuration Parameters
Setting System Configuration Parameters
SkyWay's system parameters fall into four main areas:
• Network Management Security
• Network Management System
• User Access
• General Parameters
Setting Network Management Security Parameters
Use screen 1.1.1 to set up security parameters for network management. To access
this screen, you must have an access level of Super. This screen is not accessible via
SNMP .
1.1.1 Network Management Security Configuration
1.1.1. Network Management Security Configuration
Network Management Configuration:
---------------------------------
Read Community Name
Write Community Name
Trap Community Name
Enable Traps
Authentication Traps
NMS IP Address 1
NMS IP Address 2
Trap Destination IP Address 1 :
Trap Destination IP Address 2 :
\ - return to menu
The following table lists the field name and settings (there are no MIB OIDs for this
screen):
Field Name
Read Community Name
The read-only community name of the SkyWay agent. Must match community
name configured on the Network Management Station (NMS).
Write Community Name
The read-write community name of the SkyWay agent. Must match community
name configured on the NMS.
:
public
:
:
:
No
:
No
:
000.000.000.000
:
000.000.000.000
000.000.000.000
000.000.000.000
. - commands
TAB - next available field
ENTER - edit
Settings (default in
bold)
public
59
Advertisement
Table of Contents
