Table of Contents
Advertisement
IP Routing
IP Routing
IP routing is a global parameter. It is disabled by default, but you can enable the unit for
IP routing only or in addition to bridging. You cannot configure routing on a port to
port basis.
Configuring IP
Use the 1.4.1 IP Protocol Configuration screen to enable IP routing and set global
routing parameters.
1.4.1 IP Protocol Configuration
1.4.1. IP Protocol Configuration
Routing
Time To Live
ICMP Redirect Route Clearing Interval :
Forward Broadcasts
IP Reassembly Timeout
Default Gateway:
Default Gateway Enabled
Default Gateway Ip Address
Default Gateway Port Number
The following table lists the field name, the MIB name, and the default setting:
Field Name
Routing
Enables or disables IP routing on this unit.
Time to Live
Specified the number of hops a packet can be forwarded before it is discarded.
ICMP Redirect Route
Clearing Interval
The interval of time, in seconds, in which routes learned from ICMP redirect mes-
sages are cleared.
:
Disabled
:
64
1800
:
Enabled
:
8
:
No
:
000.000.000.000
:
3
MIB
[ipForwarding]
[ipDefaultTTL]
[swIpIcmpredirectdlear-
ingInterval]
Settings (default in
bold)
Disabled
64
1800
93
Advertisement
Table of Contents
