Configuring The Ethernet Transceiver; Ethernet Transceiver Configuration - Solectek skyway series User Manual

Configuring the Ports

Configuring the Ethernet Transceiver

1.2.2.2 Ethernet Transceiver Configuration

1.2.2.2. Ethernet Transceiver Configuration
Ethernet Port Number
Interface Type
Duplex Mode
SQE (10Base-T)
Jabber (10Base-T)
Auto Negotiate
Remote Fault
Pause
100BASE-TX full-duplex :
100BASE-TX
10BASE-T full-duplex
10BASE-T
Selector Field
Record type
\ - return to menu
Field Name
Ethernet Port Number
The Ethernet port number is 2.
Interface Type
Type of interface connected to the Ethernet port.
Duplex Mode
Duplex Mode for the Ethernet transceiver.
SQE (10Base-T)
When SQE (heartbeat) function is enabled, the transceiver will assert COL output
for 5-15 BT after each packet. Valid only for 10Base-T.
: 2
: Auto-Negotiation
: Full Duplex
: Disabled
: Enabled
: Enabled
: Disabled
: Enabled
Enabled
: Enabled
: Enabled
: Enabled
: IEEE 802.3
: Valid
. - commands TAB - next available field
MIB
[swEtherTransCfgIndex]
[swEtherTransCfgInter-
face]
[swEtherTransCfgDuplex]
[swEtherTransCfgSQE]
Record 1 of 1
ENTER - e
Settings (default in
bold)
2
• • • • Auto-Negotiation Auto-Negotiation
Auto-Negotiation Auto-Negotiation
• 10BASE-T
• 100BASE-TX
• 100BASE-FX
• • • • Full Duplex Full Duplex
Full Duplex Full Duplex
• Half Duplex
• Enabled
• • • • Disabled Disabled Disabled Disabled
85