Table of Contents
Advertisement
Before Installing
28
To complete your SkyWay installation, you need the following items:
• A pair of cellular telephones or walkie-talkies, so installers can communicate
when aligning SkyWay antennas during the installation process
• (Optional: Needed only if you find it absolutely necessary to cut the indoor
connectors off to accommodate pulling the cable through conduit):
• Ethernet cable: an RJ-45 cable crimper to terminate the RJ-45 connection
to the Ethernet LAN during the installation process
• Serial cable: a small screwdriver to disassemble the DB-9 case, a pin
removal extractor tool or a replacement DB-9 jack
• Power cable: a soldering iron
For pin-out information, see "Appendix C: Interface Specifications and Pinouts"
on page 181.
• VT-100 console or a workstation with VT-100 emulation capability and termi-
nal emulation software such as Hyperterm™ or Procomm™ to configure the
SkyWay Bridge/Router
• (Optional) a modem, if you want to operate the SkyWay Bridge/Router
through a dial-up connection
• 13 mm hex socket wrench for mounting bracket
• Slotted screw driver for mounting clamps
Advertisement
Table of Contents
