Configuring The Serial Port And Serial Transceiver - Solectek skyway series User Manual

Accessing the SkyWay Bridge/Router
Example AT
Commands
3.
Set the terminal to 8-bits, No Parity, 1 Stop Bit.
4.
Dial the modem attached to the SkyWay.
You may need to write a command line to configure your modem for use with the
SkyWay. The example command line below is listed for your convenience and is not
configured through a screen on the SkyWay. The following is an example of the AT
command settings for a USRobotics V.Everything modem attached to the SkyWay.
The AT command line reads: ATQ1&A0&B1&D0&F0&H0&R1S0=1&W
Where... Where... Where... Where...
Q1
&A0
&B1
&D0
&F0
&H0
&R1
S0=1
&W
The above command line disables any flow control, fixes the speed of the serial port,
and disables any response codes back to the SkyWay unit. Make adjustments or addi-
tions to these settings based on your local configuration.
These change the default configuration; however, the modem should then boot from
the NVRAM settings.

Configuring the Serial Port and Serial Transceiver

Go to the 1.2.1.1 Serial Port Configuration, or 1.2.1.2 Serial Transceiver Configuration
screen.
Means... Means... Means... Means...
Suppress result codes
Don't display ARQ result codes
Fixed DTE speed
Ignore DTR
Load no flow control template settings
Disable transmit data flow control
Ignore RTS
Answer on first ring
Write to NVRAM
23