Rf Base Radio Test - Solectek skyway series User Manual

Diagnostics

4.1 RF Base Radio Test

4.1 RF Base Radio Test
** Note - diagnostic driver must be installed **
RF Port Number : 3
Test Timeout : 8 milliseconds
Test To Run : Terminate Test
Number of Frames or Bursts, 1 - 65535 or 0 for Continuous. :0
Frame Length or Maximum Burst Size, 3 - 3200
\ - return to menu
The following lists the field name, the MIB name, and the default setting:
Field Name
RF Port Number
The RF port number is 3.
Test Timeout
The timeout value in milliseconds. This is the amount of time the test will run before
terminating on its own.
Test to Run:
Select a test to run and press
on the base port as described in the following table. To end the test, set Test to Run
to Terminate Test and press
Test To Run
Burst Frame Ping Pong
Mode
. - commands TAB - next available field
MIB
[swRFBaseTestIndex]
[swRFBaseTestTO]
[swRFBaseTestToRun]
.W to begin the test. There are five tests you can run
.W .
Parameters that
can be configured
Test Timeout, Number
of Bursts, Maximum
Burst Size
:1530
ENTER - edit
Settings (default in
bold)
3
8
See the following table:
Comments
The base station sends
the specified number of
bursts, and the sub sta-
tion returns the same
number.
105