Table of Contents
Advertisement
Note
80
Configuring the Base Sub Ports
If you have disabled ADP , you must manually configure the base sub ports on the base
station using the 1.2.3.1.3 RF Base Sub Port Configuration screen. If you have ADP
enabled, you do not need to configure base sub ports.
1.2.3.1.3 RF Base Sub Port Configuration
1.2.3.1.3 RF Base Sub Port Configuration
Sub Station Number
Configuration Status
Port Type
Corresponding Substation RF Port
IP Address
Record Type
\ - return to menu
Type
.A to add a base sub port and to begin editing.
The following table lists the field name, MIB, and the default or field options with the
default setting in bold:
Field Name
Sub Station Number
The sub station number for this Base to Sub station port.
Configuration Status
Determines if the port is enabled during initialization (On-line). Set to off-line to dis-
able the port.
Port Type
This read-only field defines this port as a RF-DLC Base to Sub station port.
Corresponding Substation
RF Port IP Address
The IP address of the sub station.
:256
:On-line
:RF-DLC Base to Sub Port
:000.000.000.000
:Valid
. - commands
TAB - next available field
MIB
[swRFBaseSubPortIndex]
[swRFBaseSubPortCon-
figStatus]
[swRFBaseSubPortPort-
Type]
[swRFBaseSubPortSub-
RFIPAddr]
Record 1 of 1
ENTER - edit
Settings (default in
bold)
256
• • • • On-line
On-line
On-line
On-line
• Off-line
RF-DLC Base to Sub Port
000.000.000.000
Advertisement
Table of Contents
