Flash Signal Detection (Used To Manage Two Calls Simultaneously) - Sagem RT3000 User Manual

Meaning:
TTTT
= the duration of the time out :
Min value =
Max value =
Option: If activated you can stop the dial timeout by pressing
digit of the phone number (fast dialling key). (Default: Not activated; to activate this
function please check the User manual)
8.7.3 Flash signal detection (used to manage two calls
simultaneously)
The RT3000 is capable to detect the so called Flash signal.
On most telephone sets the Flash signal is sent by pressing the
seldom cases the length of the Flash signal of a telephone differs from the standard the
SAGEM RT3000 is configured for by default. If the SAGEM RT3000 does not detect
the Flash signal of your telephone in the right way please adjust the setting of the
SAGEM RT3000 using the following DTMF codes:
For the Telephone port:
Default access code:
*5 ACCESS 014 MIN #
*5 ACCESS 015 MAX #
For the Fax/Modem/Phone port:
Default access code:
*5 ACCESS 016 MIN #
*5 ACCESS 017 MAX #
Meaning:
All Flash signals with a duration >
MIN
With =
MAX
With =
SAGEM RT3000
400
1200
Recommended value: 600 (= 6 s)
000000
000000
7 55
.... : that means 70 ms .... 550 ms
12 65
.... : that means 120 ms .... 650 ms
: 400 * 10 ms = 4 s
: 1200 * 10 ms = 12 s
MIN MAX
and <
Configuration
#
after the last entered
R
key. In some
Description:
Minimum duration
Maximum duration
Description:
Minimum duration
Maximum duration
will be detected.
37