Mnp Flow Control; Maximum Local Modem Speed; Minimum Local Modem Speed - Sagem RT3000 User Manual

Hang-up delay port
B

16.27 MNP Flow Control

The Microcom Networking Protocol MNP is used for error correction and flow control
on the link to the local connected Modem. If you want MNP active set the following
parameter as follows: MNP=YES
Section: MODEM
Meaning
MNP setting

16.28 Maximum local modem speed

This parameter sets the initial baudrate for the negotiation.
Section: MODEM
Meaning
max. local speed

16.29 Minimum local modem speed

This parameter sets the lowest speed accepted during baudrate negotiation.
Section: MODEM
Meaning
min. local speed
SAGEM RT3000
Parameters in the file para.ini: advanced configuration
CHB_MTC_HOOK_TIMEOUT
.
Parameter
MNP
Parameter
MAX_SPEED
Parameter
MIN_SPEED
0....30000
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
Permitted Values
YES,NO
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
Permitted Values
300, 1200, 2400,
4800, 9600, 14400
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
Permitted Values
300, 1200, 2400,
4800, 9600, 14400
6000 = 1min
Factory Setting
YES
(NO in Spain)
Factory Setting
9600
Factory Setting
300
101