Configuration Of Network Services - Sagem RT3000 User Manual

Configuration
Fax/Modem/Phone port:
To change the setting enter the following sequence:
Default access code:
*5 ACCESS 003 VV
*5 ACCESS 004 VV
Meaning:
Factory setting: 07
Example:
You want to increase the volume of voice signals received from the remote party
when you use the Telephone port:
Lift up the handset
then enter:
and wait for the confirmation tone
then hang-up the handset
8.3

Configuration of network services

Your SAGEM RT3000 is a sophisticated device with a wide range of modes of
operation. You have to decide which operation modes are appropriate for your needs
and then enable them by configuring the SAGEM RT3000.
The configuration
process
The icons in the following descriptions mean:
24
000000
,
*5 000000 002 03 #
Use a telephone connected to the Telephone port or the
Fax/Modem/Phone port of the RT3000 to enter a special
sequence (see below) just as you would dial a number. (The
telephone must use tone (= DTMF) dialling.)
listen to the confirmation tone:
a high pitched beep signals: OK
a low frequency beep-beep signals: Wrong entry.
You may have to wait 3 seconds before hearing the confirmation
tone.
lift up the handset.
#
#
VV = 00 .... 20
with 00 = maximum volume
with 20 = minimum volume
,
.
Description:
Volume sent to
remote party
Volume of voice
signals received
from remote party
SAGEM RT3000