In Case Of A Fax Warning - Sagem RT3000 User Manual

Operation: Send and receive fax with a facsimile device
5.2

In case of a FAX Warning

If both FAX Warning LEDs are rapidly flashing, the SAGEM RT3000 is indicating that it
could not transfer a received fax to the connected facsimile device completely (see
above). The part that is not transferred is stored in the SAGEM RT3000. Please check
your facsimile device. Be sure that it is in correct operation mode. Then give the
command to the SAGEM RT3000 to transfer the stored fax to your facsimile device.
Use a telephone connected to the Telephone port or to the Fax/Modem/Phone port to
give the following command:
#*222#
#*999#
!
You can configure the fax function according your needs. See page 31.
18
Description:
After you have entered the code, the SAGEM
RT3000 will start to send the saved fax part to
your facsimile device.
This command will delete the partly saved fax
and will reset the FAX Warning.
means: wait for the confirmation tone (up to 3 sec):
a high pitched beep signals: OK
a low frequency beep-beep signals: Wrong entry.
SAGEM RT3000