At Command Parameter; Polarity Reversal (Spain); Hang-Up Delay - Sagem RT3000 User Manual

Parameters in the file para.ini: advanced configuration

16.24 AT command parameter

The settings you enter by AT commands are stored in the configuration file para.ini in
an own section.
This section is reserved.

16.25 Polarity reversal (Spain)

This function simulates the Polarity reversal feature provided on the Spanish fixed
telephone network, but there are some differences, caused by the adaptation to the
wireless environment.
Section: DIALLING
Meaning
Polarity reversal
on/off on port A
Polarity reversal
on/off on port B

16.26 Hang-up delay

This function allows, in case of an incoming call to answer the call, to hang-up the call
and to continue the call, if you pick-up the phone again within the selected delay, if the
remote party has not yet terminate the call. This function is always active, if the
Polarity reversal has been activated. If the Polarity reversal function is off you may
activate the Hang-up delay by parameter.
Section: DIALLING
Meaning
Hang-up delay
on/off port A
Hang-up delay port
A
Hang-up delay
on/off port B
100
Parameter
CHA_POLARITY_REV
CHB_POLARITY_REV
Parameter
CHA_MTC_HOOK_DELAY
CHA_MTC_HOOK_TIMEOUT
CHB_MTC_HOOK_DELAY
Can be configured by AT-command (see p. 62)
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
Permitted Values
YES,NO
YES,NO
Can be configured by SMS (see page 82)
Can be configured by FTP (see page 83)
Permitted
Values
YES, NO
0....30000
YES, NO
Factory Setting
NO
NO
Factory Setting
NO
6000 = 1min
NO
SAGEM RT3000