Additional Configuration; Enable/Disable Clir (Calling Line Identification Restriction); Dialling Timeout - Sagem RT3000 User Manual

Configuration
8.7

Additional Configuration

8.7.1

Enable/Disable CLIR (Calling Line Identification Restriction)

(CLIR = Calling Line Identification Restriction) When you are making a call, your
telephone number will be displayed to the called party, if there is the right equipment
available.
To change the setting enter the following sequence:
Default access code:
*5 ACCESS 007 0 #
*5 ACCESS 007 1 #
8.7.2

Dialling Timeout

The SAGEM RT3000 must wait until you have dialled the complete telephone number
before it will establish the connection to the remote station. To detect the end of your
dialling it waits for a certain duration of time (the dial timeout) after each entered digit.
If you do not enter a further digit during this dial timeout the device "thinks" that you
have finished to enter the dial sequence and so it will start to establish the connection.
You can configure the duration of this period of time (dial timeout):
(Default: 600 = 6 sec.)
For the Telephone port:
Default access code:
*5 ACCESS 005 TTTT #
For the Fax/Modem/Phone port:
Default access code:
*5 ACCESS 006 TTTT #
36
000000
000000
000000
Description:
Phone number will
not be displayed to
called party
Phone number will
be displayed to
called party
Description:
Dial Timeout
Description:
Dial Timeout
SAGEM RT3000