Configuration Of Tones - Sagem RT3000 User Manual

Configuration of Tones

17 Configuration of Tones
Tones generated by the RT3000 can be configured by editing the parameter file
tone.ini. You can access this file in the same way as the parameter file para.ini. Refer
to page 83.
TONES
Dial tone CHA_DIAL_TONE
Ring back tone CHA_CALL_CTRL
Busy tone CHA_BUSY_TONE
Call wait tone CHA_CALL_WAIT
Programming
acceptance tone
Programming non-
acceptance tone
PIN last try tone CHA_PIN_LAST
SIM missing tone CHA_SIM_MISS
Available frequencies are in the range from 300Hz up to 1500Hz in steps of 5Hz.
Example: CHA_DIAL_TONE=425 sets the frequency for the dial tone of channel A to
425 Hz
TONE_LEVEL
Level CHA_TONE_LEVEL
Available gains are in range from 0dB down to –30dB in steps of 1dB.
Example: CHA_TONE_LEVEL=0 sets the gain to 0dB for channel A
112
In the section TONES The frequencies of all available slic
generated tones can be defined. Entering invalid values will
provoke the default settings. You can define the following tones:
Telephone port
CHA_ACPT_PROG
CHA_NACPT_PROG
In the section TONE_LEVELS, the gain of the generated tones on
the SLIC ports can be defined. Following parameters are available
in this section for the tone gain on channel a and b.
Telephone port
default
[Hz] Phone/Fax/Modem port
425 CHB_DIAL_TONE
440 CHB_CALL_CTRL
425 CHB_BUSY_TONE
440 CHB_CALL_WAIT
950 CHB_ACPT_PROG
300 CHB_NACPT_PROG
600 CHA_PIN_LAST
950 CHB_SIM_MISS
default
[dB] Phone/Fax/Modem port
0 CHB_TONE_LEVEL
default
[Hz]
425
440
425
440
950
300
600
950
default
[dB]
0
SAGEM RT3000