Configuration
8
Configuration
Your SAGEM RT3000 is a sophisticated device with a wide range of modes of
operation. You have to decide which operation modes are appropriate for your needs
and then enable them by configuring the SAGEM RT3000.
The configuration
process
The icons in the following descriptions mean:
ACCESS
8.1
Access code for DTMF configuration
8.1.1
Changing the DTMF access code
The configuration of your SAGEM RT3000 is protected against unauthorised
modification by an access code. The access code is part of each DTMF configuration
code apart from the DTMF codes to configure call forwarding and call barring.
The access code consists of 6 numeric digits. The default value is
*5 OLDACC 023 NewACC #
It means:
OLDACC
newACC
22
Use a telephone connected to the Telephone port or the
Fax/Modem/Phone port of the RT3000 to enter a special
sequence (see below) just as you would dial a number. (The
telephone must use tone (= DTMF) dialling.)
listen to the confirmation tone:
a high pitched beep signals: OK
a low frequency beep-beep signals: Wrong entry.
You may have to wait 3 seconds before hearing the confirmation
tone.
lift up the handset.
hook on the handset.
means: access code; by default it is
: old access code
: new access code
000000
000000.
SAGEM RT3000