Example-File - Sagem RT3000 User Manual

•
Example 3: NON_ACCEPT_PROGRAMMING on channel b
CHB_NON_ACPT_PROG=10,50,10,50,-100
% 10 = tone on for 10*10ms = 100ms
% 50 = tone off for 50*10ms = 500ms
% 10 = tone on for 10*10ms = 100ms
% 50 = tone off for 50*10ms = 500ms
% -100= timing sequence terminator. This timing sequence ends here. Tone
generators stops with the actual (tone off) setting
All programmed timings, levels and frequencies were read from TONE.INI only once at
the startup of the device. After changes have been made, a reset of the device must
been done, to use them.
17.2

Example-File:

;RT-XNG Tone-Parameter File
[TONES]
;settings for channel a
CHA_DIAL_TONE=425
CHA_CALL_CTRL=440
CHA_BUSY_TONE=425
CHA_CALL_WAIT=440
CHA_ACPT_PROG=950
CHA_NACPT_PROG=300
CHA_PIN_LAST=600
CHA_SIM_MISS=950
;settings for channel b
CHB_DIAL_TONE=425
CHB_CALL_CTRL=440
CHB_BUSY_TONE=425
CHB_CALL_WAIT=440
CHB_ACPT_PROG=950
CHB_NACPT_PROG=300
CHB_PIN_LAST=600
CHB_SIM_MISS=950
[TONE_LEVEL]
SAGEM RT3000
Configuration of Tones
115