Verifying the configuration
# Display statistics for MLD messages and IPv6 PIM hello messages learned through MLD snooping
on Switch B.
[SwitchB] display mld-snooping statistics
Received MLD general queries:
Received MLDv1 specific queries:
Received MLDv1 reports:
Received MLD dones:
Sent
MLDv1 specific queries:
Received MLDv2 reports:
Received MLDv2 reports with right and wrong records:
Received MLDv2 specific queries:
Received MLDv2 specific sg queries:
Sent
MLDv2 specific queries:
Sent
MLDv2 specific sg queries:
Received IPv6 PIM hello:
Received error MLD messages:
The output shows that all switches except Switch A can receive the MLD general queries after Switch
A acts as the MLD snooping querier.
MLD snooping proxying configuration example (for VLANs)
Network requirements
As shown in
snooping. Configure MLD snooping proxying so that Switch A can perform the following actions:
•
Forward MLD report and done messages to Router A.
•
Respond to MLD queries sent by Router A and forward the queries to downstream hosts.
Figure 92 Network diagram
Source
HGE1/0/2
1::1/64
12
0
0
0
Figure
92, Router A runs MLDv1 and acts as the MLD querier. Switch A runs MLDv1
HGE1/0/1
1::2/64
2001::1/64
Router A
MLD querier
3
0
0
0
0
0
0
0
Receiver
Host A
HGE1/0/4
HGE1/0/1
HGE1/0/3
Switch A
HGE1/0/2
Proxy
Host C
314
0
Receiver
Host B
VLAN 100