HP FlexFabric 5950 series Configuration Manual page 94

Figure 31 Network diagram
Switch A
Vlan-int200
50.1.1.1/24
Static multicast route
Configuration procedure
1. Assign an IP address and subnet mask for each interface, as shown in
shown.)
2. Configure OSPF on the switches in the PIM-DM domain. (Details not shown.)
3. Enable IP multicast routing, and enable IGMP and PIM-DM:
# On Switch B, enable IP multicast routing.
<SwitchB> system-view
[SwitchB] multicast routing
[SwitchB-mrib] quit
# Enable IGMP on the receiver-side interface (VLAN-interface 100).
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] igmp enable
[SwitchB-Vlan-interface100] quit
# Enable PIM-DM on other interfaces.
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] pim dm
[SwitchB-Vlan-interface101] quit
[SwitchB] interface vlan-interface 102
[SwitchB-Vlan-interface102] pim dm
[SwitchB-Vlan-interface102] quit
# On Switch A, enable IP multicast routing.
<SwitchA> system-view
[SwitchA] multicast routing
[SwitchA-mrib] quit
# Enable PIM-DM on each interface.
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] pim dm
Switch C
Vlan-int103
40.1.1.1/24
PIM-DM
Vlan-int103
40.1.1.2/24
Vlan-int102
30.1.1.2/24
Source
50.1.1.100/24
Vlan-int101
20.1.1.2/24
Vlan-int101
20.1.1.1/24
Switch B
Vlan-int102
30.1.1.1/24
Vlan-int100
10.1.1.1/24
Receiver
10.1.1.100/24
84
Figure 31. (Details not