HP FlexFabric 5950 series Configuration Manual page 258

[PE3] multicast routing
[PE3-mrib] quit
# Create service loopback group 1, and specify the multicast tunnel service for the group.
[PE3] service-loopback group 1 type multicast-tunnel
# Assign HundredGigE 1/0/4 to service loopback group 1. The interface does not belong to
VLAN 17, VLAN 18, or VLAN 19.
[PE3] interface hundredgige 1/0/4
[PE3-HundredGigE1/0/4] port service-loopback group 1
[PE3-HundredGigE1/0/4] quit
# Configure an LSR ID, and enable LDP globally.
[PE3] mpls lsr-id 1.1.1.3
[PE3] mpls ldp
[PE3-ldp] quit
# Create a VPN instance named a, and configure the RD and route targets for the VPN
instance.
[PE3] ip vpn-instance a
[PE3-vpn-instance-a] route-distinguisher 100:1
[PE3-vpn-instance-a] vpn-target 100:1 export-extcommunity
[PE3-vpn-instance-a] vpn-target 100:1 import-extcommunity
[PE3-vpn-instance-a] quit
# Enable IPv6 multicast routing for VPN instance a.
[PE3] ipv6 multicast routing vpn-instance a
[PE3-mrib6-a] quit
# Create an MD for VPN instance a.
[PE3] multicast-domain vpn-instance a
# Create an MD IPv6 address family for VPN instance a.
[PE3-md-a] address-family ipv6
# Specify the default-group, the MD source interface, and the data-group range for VPN
instance a.
[PE3-md-a-ipv6] default-group 239.1.1.1
[PE3-md-a-ipv6] source loopback 1
[PE3-md-a-ipv6] data-group 225.2.2.0 28
[PE3-md-a-ipv6] quit
[PE3-md-a] quit
# Create a VPN instance named b, and configure the RD and route targets for the VPN
instance.
[PE3] ip vpn-instance b
[PE3-vpn-instance-b] route-distinguisher 200:1
[PE3-vpn-instance-b] vpn-target 200:1 export-extcommunity
[PE3-vpn-instance-b] vpn-target 200:1 import-extcommunity
[PE3-vpn-instance-b] quit
# Enable IPv6 multicast routing for VPN instance b.
[PE3] ipv6 multicast routing vpn-instance b
[PE3-mrib6-b] quit
# Create an MD for VPN instance b.
[PE3] multicast-domain vpn-instance b
# Create an MD IPv6 address family for VPN instance a.
[PE3-md-b] address-family ipv6
248