Sa Message Filtering Configuration - HP FlexFabric 5950 series Configuration Manual

# Display the PIM routing table on Switch D.
[SwitchD] display pim routing-table
Total 1 (*, G) entry; 1 (S, G) entry
(*, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: WC
UpTime: 00:12:07
Upstream interface: Register
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface200
(10.110.6.100, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: SPT 2MSDP ACT
UpTime: 00:40:22
Upstream interface: Vlan-interface104
Upstream neighbor: 10.110.4.2
RPF prime neighbor: 10.110.4.2
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface200
The output shows that Switch D now acts as the RP for Source 2 and Host B.

SA message filtering configuration

Network requirements
As shown in
•
OSPF runs within and among the PIM-SM domains to provide unicast routing.
•
Set up an MSDP peering relationship between Switch A and Switch C and between Switch C
and Switch D.
•
Source 1 sends multicast data to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Source 2
sends multicast data to the multicast group 227.1.1.0/30.
Configure SA message policies so that:
•
Host A and Host B receive the multicast data only addressed to multicast groups 225.1.1.0/30
and 226.1.1.0/30.
•
Host C receives the multicast data only addressed to multicast groups 226.1.1.0/30 and
227.1.1.0/30.
Protocol: igmp, UpTime: 00:12:07, Expires: -
Protocol: pim-sm, UpTime:
Figure 67:
- , Expires: -
197