Troubleshooting Multicast Routing And Forwarding; Static Multicast Route Failure - HP FlexFabric 5950 series Configuration Manual

Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface200
(10.1.1.100, 225.1.1.1)
Protocol: pim-dm, Flag: ACT
UpTime: 00:06:14
Upstream interface: Tunnel2
Upstream neighbor: 50.1.1.1
RPF prime neighbor: 50.1.1.1
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface200
The output shows that Switch A is the RPF neighbor of Switch C and the multicast data from Switch
A is delivered over the GRE tunnel to Switch C.

Troubleshooting multicast routing and forwarding

Static multicast route failure

Symptom
No dynamic routing protocol is enabled on the routers, and the physical status and link layer status of
interfaces are both up, but the static multicast route fails.
Solution
To resolve the problem:
1. Use the display multicast routing-table static command to display information about static
multicast routes. Verify that the static multicast route has been correctly configured and that the
route entry exists in the static multicast routing table.
2. Check the type of interface that connects the static multicast route to the RPF neighbor. If the
interface is not a point-to-point interface, be sure to specify the address for the RPF neighbor.
3. If the problem persists, contact Hewlett Packard Enterprise Support.
Protocol: igmp, UpTime: 00:04:25, Expires: -
Protocol: pim-dm, UpTime: 00:04:25, Expires: -
90