Displaying And Maintaining Multicast Vpn - HP FlexFabric 5950 series Configuration Manual

Step
1. Enter system view.
2. Enter BGP instance view.
3. Enter BGP IPv4 MDT
address family view.
4. Configure the device as a
route reflector and specify its
peers or peer groups as
clients.
5. (Optional.) Disable route
reflection between clients.
6. (Optional.) Configure the
cluster ID of the route
reflector.

Displaying and maintaining multicast VPN

Execute display commands in any view and reset commands in user view.
Task
Display BGP MDT peer group
information.
Display information about BGP
MDT peers or peer groups.
Display BGP MDT routing
information.
Display information about BGP
update groups for the BGP IPv4
MDT address family.
Display information about
data-groups for IPv4 multicast
transmission that are received in
a VPN instance.
Display information about
data-groups for IPv6 multicast
transmission that are received in
a VPN instance.
Display information about
data-groups for IPv4 multicast
transmission that are sent in a
VPN instance.
Command
system-view
bgp as-number [ instance
instance-name ]
address-family ipv4 mdt
peer { group-name |
ip-address [ mask-length ] }
reflect-client
undo reflect between-clients
reflector cluster-id { cluster-id
| ip-address }
Command
display bgp [ instance instance-name ] group ipv4
mdt [ group-name group-name ]
display bgp [ instance instance-name ] peer ipv4 mdt [ ip-address
mask-length | { ip-address | group-name group-name } log-info |
[ ip-address ] verbose ]
display bgp [ instance instance-name ] routing-table ipv4 mdt
[ route-distinguisher route-distinguisher ] [ ip-address
[ advertise-info ] ]
display bgp [ instance instance-name ] update-group ipv4 mdt
[ ip-address ]
display
multicast-domain vpn-instance vpn-instance-name data-group
receive [ brief | [ active | group group-address
| sender source-address | vpn-source-address [ mask { mask-length
| mask } ] | vpn-group-address [ mask { mask-length | mask } ] ] * ]
display multicast-domain vpn-instance vpn-instance-name ipv6
data-group receive [ brief | [ active | group group-address
| sender source-address | vpn-source-address [ mask-length ]
| vpn-group-address [ mask-length ] ] * ]
display
multicast-domain vpn-instance vpn-instance-name data-group sen
d [ group group-address | reuse interval | vpn-source-address [ mask
{ mask-length | mask } ] | vpn-group-address [ mask { mask-length
| mask } ] ] *
226
Remarks
N/A
N/A
N/A
By default, neither route reflectors
nor clients exist.
By default, route reflection between
clients is disabled.
For more information about this
command, see Layer 3—IP
Routing Command Reference.
By default, a route reflector uses its
router ID as the cluster ID.
For more information about this
command, see Layer 3—IP
Routing Command Reference.