HP FlexFabric 5950 series Configuration Manual page 172

•
IGMPv2 runs between Switch B and Host A, and between Switch D and Host B.
Figure 58 Network diagram
Receiver 1
Host A
Source 1
Table 12 Interface and IP address assignment
Device
Switch A
Switch A
Switch B
Switch B
Switch B
Switch C
Switch C
Switch C
Configuration procedure
1. Assign an IP address and subnet mask to each interface, as shown in
shown.)
2. Configure OSPF on the switches in the BIDIR-PIM domain. (Details not shown.)
3. Enable IP multicast routing, PIM-SM, BIDIR-PIM, and IGMP:
# On Switch A, enable IP multicast routing, enable PIM-SM on each interface, and enable
BIDIR-PIM.
<SwitchA> system-view
[SwitchA] multicast routing
[SwitchA-mrib] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] pim sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim sm
[SwitchA-Vlan-interface101] quit
Switch B
Vlan-int200 Vlan-int102
Vlan-int101
Vlan-int101
Vlan-int100
Switch A
Interface IP address
Vlan-int100 192.168.1.1/24
Vlan-int101 10.110.1.1/24
Vlan-int200 192.168.2.1/24
Vlan-int101 10.110.1.2/24
Vlan-int102 10.110.2.1/24
Vlan-int102 10.110.2.2/24
Vlan-int103 10.110.3.1/24
Loop0 1.1.1.1/32
Loop0
Vlan-int102
Vlan-int103
BIDIR-PIM
Vlan-int103
Switch D
Device Interface
Switch D Vlan-int300
Switch D Vlan-int400
Switch D Vlan-int103
Source 1 —
Source 2 —
Receiver 1 —
Receiver 2 —
162
Receiver 2
Switch C
Host B
Source 2
Vlan-int400
IP address
192.168.3.1/24
192.168.4.1/24
10.110.3.2/24
192.168.1.100/24
192.168.4.100/24
192.168.2.100/24
192.168.3.100/24
Figure 58. (Details not