Enabling Basic Qinq; Configuring Selective Qinq (Available Only On The Hpe 3100 V2 Ei); Configuring An Outer Vlan Tagging Policy In The Port-Based Approach - HP 3100 Series Configuration Manual

Enabling basic QinQ

A basic QinQ-enabled port tags an incoming packet with its PVID.
To enable basic QinQ:
Step
Enter system view.
1.
Enter interface view
2.
or port group view.
Enable basic QinQ.
3.
Configuring selective QinQ (available only on the
HPE 3100 v2 EI)
Basic QinQ can only tag received frames with the PVID of the receiving port. Selective QinQ allows
adding different outer VLAN tags based on different inner VLAN tags.
You can configure an outer VLAN tagging policy in one of the following approaches:
•
Port-based approach
•
QoS policy-based approach
Configuring an outer VLAN tagging policy in the port-based
approach
Step
Enter system view.
1.
Enter interface view or port
2.
group view.
Enter QinQ view and configure
3.
the SVLAN tag for the port to
add.
Tag frames of the specified
4.
CVLANs with the current
SVLAN.
Command
system-view
•
Enter Layer 2 Ethernet interface view or
Layer 2 aggregate interface view:
interface interface-type interface-number
•
Enter port group view:
port-group manual port-group-name
qinq enable
Command
system-view
•
Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
qinq vid vlan-id
raw-vlan-id inbound { all |
vlan-list }
153
Remarks
N/A
Use either command.
Disabled by default
Remarks
N/A
Use either command.
By default, the SVLAN tag to be
added is the PVID of the
receiving port.
N/A