Enabling Igmp Snooping Proxying; Configuring Parameters For Igmp Messages; Configuration Prerequisites - HP FlexFabric 5950 series Configuration Manual

Configuring parameters for IGMP general queries and responses globally
Step
1. Enter system view.
2. Enter IGMP-snooping view.
3. Set the maximum response
time for IGMP general
queries.
Configuring parameters for IGMP general queries and responses in a VLAN or VSI
Step
1. Enter system view.
2. Enter VLAN view or VSI
view.
3. Set the IGMP general query
interval in the VLAN or VSI.
4. Set the maximum response
time for IGMP general
queries in the VLAN or VSI.

Enabling IGMP snooping proxying

Before you enable IGMP snooping proxying for a VLAN, enable IGMP snooping for the VLAN.
To enable IGMP snooping proxying:
Step
1. Enter system view.
2. Enter VLAN view.
3. Enable IGMP snooping
proxying for the VLAN.

Configuring parameters for IGMP messages

This section describes how to configure parameters for IGMP messages.

Configuration prerequisites

Before you configure parameters for IGMP messages, complete the following tasks:
•
Enable IGMP snooping for the VLAN or VSI.
•
Determine the source IP address of IGMP general queries.
•
Determine the source IP address of IGMP group-specific queries.
•
Determine the source IP address of IGMP reports.
•
Determine the source IP address of IGMP leave messages.
Command
system-view
igmp-snooping
max-response-time seconds
Command
system-view
•
Enter VLAN view:
vlan vlan-id
•
Enter VSI view:
vsi vsi-name
igmp-snooping
query-interval interval
igmp-snooping
max-response-time seconds
Command
system-view
vlan vlan-id
igmp-snooping proxy enable
27
Remarks
N/A
N/A
The default setting is 10 seconds.
Remarks
N/A
N/A
The default setting is 125 seconds.
The default setting is 10 seconds.
Remarks
N/A
N/A
By default, IGMP snooping
proxying is disabled for a VLAN.